See also: Rob™ QPCR reproducibility | Speed Accuracy & Precision | Liquid Level Detection (LLD) | OneDip™ QPCR reproducibility


Rob™ has two modes for doing QPCR set-up. Traditional mode uses one tip for every sample replicate and OneDip™ mode uses the same tip for all replicates doing serial dispensing. The example below is based on a QPCR set-up with three replicates and pre-made master mix.

One tip per replicate

96-plate: 27 minutes (18 µl mix + 2 µl sample)
384-plate: 95 minutes (5 µl mix + 2 µl sample)


96-plate: 13 minutes (18 µl mix + 2 µl sample)
384-plate: 45 minutes (5 µl mix + 2 µl sample)

Rob™ handles a 384 set-up with acceptable speed but with low investment cost.

AlphaHelix Technologies AB
Penarp 1150
SE 264 91 Klippan 

Tel: +46 18 12 07 01
Read more about Rob™
- Meet Rob™

Read more about ForenSafe™
- ForenSafe™ – a polymerase with improved performance
for contaminated forensic samples
Read more about The BugScreener™
The BugScreener™ - the optimal solution for MRSA screening

Read more about αAmp 
- About  αAmp 
- Benchmark
- Testimonials